Chapter 6 · ASM170/175 · 54 questions
If you turn the ignition switch to OFF in flight, will the engine shutdown?
In flight the FADEC disregards the OFF position of the ignition switch. (T/F)
When is a crossbleed start used, and what happens?
What happens to the bleed pressure DURING a crossbleed start after the operating engine thrust lever has been increased to provide adequate bleed pressure for the start?
Selecting the ignition switch to OVRD causes what to occur?
Placing the thrust levers in ____ position selects takeoff, maximum continuous, or go-around mode settings.
What methods are available for engine starting?
Where can engine oil quantity be checked?
If two consecutive overspeed detection events occur within 30 seconds the FADEC will not relight the engine. (T/F)
If you turn the START/STOP selector to STOP in flight, will the engine shutdown?
What position must the thrust lever be in to enable the thrust reverser trigger?
What controls the engine?
What controls engine starting and provides hung start, hot start, and no light off protection?
Does the FADEC provide engine start protection?
Is there protection for hot starts or hung starts during an in flight start?
How are engine thrust ratings controlled?
What does the cyan line on the N1 gauge represent during an approach?
When does the cyan line on the N1 gauge in icing conditions during an approach appear?
How is the N1 limit indicated on the EICAS?
Where is external air for an air start connected?
Will the crew have any indication when external air for an air start is connected?
What happens after three overspeed detection events within 30 seconds?
What does WML mean on the engine indication?
What is ATTCS?
What does ATTCS provide?
What will trigger an ATTCS event?
What is ATTCS controlled by?
When is ATTCS available?
How can the pilot manually command RSV power?
What do the ATTCS label colors on the EICAS represent?
When does the ATTCS system engage?
When is thrust reverse available?
When is the thrust reverser displayed on the EICAS?
Thrust reverser must be stowed below what airspeed?
What does a Green REV indication on EICAS mean?
What does an amber REV indication on EICAS mean?
What does a Red REV indication on EICAS mean?
What happens if a thrust reverser inadvertently deploys in flight?
If the thrust lever is placed in the MAX REV position and then released, it does what?
Can you deploy the thrust reverser on an engine that has failed on the landing roll?
What is a Flexible Thrust Takeoff?
What is the maximum flex allowed?
If you input a flex of 34, then change it to 39, how will it affect your N1 target?
Does the use of "wet" runway analysis numbers consider the increased stopping distance that occurs on wet runways?
If the thrust levers are not set in the TOGA detent by 60 kt which EICAS message will display?
What is the Memory Item for ENGINE ABNORMAL START?
Thrust reversers must be stowed below?
Before applying takeoff thrust, allow the engines to warm up for a minimum of ____ minute(s).
A ____ minute cool down must be observed prior to shutting down an engine.
In reference to SOP Chapter 3 Limitations, Red EICAS Engine Limit Display Markings mean? (C)
What do amber EICAS Engine Limit Display Markings mean? (C)
What do green EICAS Engine Limit Display Markings mean? (C)
Reduced thrust takeoffs are prohibited when?
When is single engine taxi not authorized?